Description
EC-30™ is designed to penetrate ½ to 1 inch into the base and sub-base of stabilized limestone, gravel, and caliche bases. Traditionally known as cutback asphalts, prime coats have been known to most effectively cure sub-base and base materials, while also being scrutinized for un-environmental application methods. EC-30™ was designed as a hydrocarbon-free alternative.
Application
Apply EC-30™ by spray. The emulsion is chemically stabilized; care should be taken not to upset the chemical balance with contamination by chemicals, over-exposure to air, or adverse mechanical or thermal conditions. DO NOT DILUTE WITH ADDITIONAL WATER. Do not apply when temperatures are below 40°F (keep from freezing). Do not mix or dilute with compounds containing solvents such as mineral spirits or petroleum distillates.
Application rate
0.15–0.30 gallons per square yard
Features
- Bonds HMA layer to the base
- Penetrates deeper than conventional emulsified asphalts (½ to 1 inch)
- Cures and evaporates faster than traditional cutbacks
- Does not contain hydrocarbons
- Does not require blotter sand
- Dries in 2–3 hours
- Does not require heat to maintain in applicable conditions
- Substantially reduced EPA concerns on air and water contamination
- Dust control properties
Typical properties
Appearance: brown odourless liquid. Solubility: miscible. Specific gravity: 1.02. Flammability: non-flammable. Min temp: 40°F. Max temp: 140°F. Shelf life: 12 months.
Availability
Available in 205lt and 1000lt containers.
This Technical Data Sheet summarises our best knowledge of the product, including how to use and apply the product based on the information available at the time. Evenrange Pty Ltd does not accept any liability either directly or indirectly for any loss suffered in connection with the use or application of the product whether in accordance with any advice, specification, recommendation, or information given.
Evenrange Pty Ltd | 12 Frankston Gardens Drive, Carrum Downs VIC 3201 | ABN 92 062 754 545 | Phone: 03 9782 3233