Description
Stripcure 12P is a specifically formulated stripper for the removal of hydrocarbon-based curing compounds that are slow in oxidizing due to the lack of UV, or have been applied thickly to the concrete, creating irregular patterns and high film build-up. This material works by dissolving the hydrocarbon and does not allow the cure to reform.
Application
Before application, ensure the surface to be treated is dry to eliminate dilution of Stripcure 12P. Apply Stripcure 12P undiluted by brush, roller or spray to the surface to be treated. Allow the product to penetrate the surface of the concrete for 10 to 20 minutes (depending on the thickness of the original film). Once emulsification has been achieved, the surface can be pressure washed to remove the residue, leaving the surface clean with no staining.
Application rate
5–10 m² per litre (depending on thickness of the coating)
Features
- Suitable for interior and exterior concrete surfaces
- Fair to good chemical and oil resistance
- Low odour, low toxicity, and non-flammable
- Rapid drying and reduced recoating downtime
- Excellent gloss retention
Typical uses
- Stencil and slate impression removal
- Precast concrete preparation
- General concrete surface preparation
- Concrete driveways
This Technical Data Sheet summarises our best knowledge of the product, including how to use and apply the product based on the information available at the time. Evenrange Pty Ltd does not accept any liability either directly or indirectly for any loss suffered in connection with the use or application of the product whether in accordance with any advice, specification, recommendation, or information given.
Evenrange Pty Ltd | 12 Frankston Gardens Drive, Carrum Downs VIC 3201 | ABN 92 062 754 545 | Phone: 03 9782 3233